I think these should be “French (Canada)” and “Spanish (Latin America)” but I need confirmation from some linguists/native speakers. However, in the 2nd Gen there are additional 2 languages. I took the list of supported languages from the documentation to the Ring Keypad 1st Gen. I have a small request to all Spanish and French speakers: there is the possibility to select the language in the configuration. The opposite synchronization is not enabled but I don’t see any reason to automate it in that way.ĭisclaimer: as the driver is related to safety and security and I cannot guarantee that it will work as intended, please don’t rely solely on it. Changing the state in STHM will change it also in the keypad. I noticed that the alarm system state is synchronized with STHM without any automation. If anyone knows a better solution for that, please let me know. I did a hack for turning off the alarms: I send once again the current state of the alarm system but without sound and light. I decided to publish the driver here but I plan to update it only with fixes or new fingerprints. So if you want to use this driver, you must upload it on your own. I don’t want to maintain the driver - there may be some breaking changes in the future.the driver was written especially for my needs and it is hard to write a general driver to meet everybody’s expectations - feel free to fork and adapt to your own requirements.I am not publishing the driver in the SmartThings Edge driver channel for two reasons: They are handled in the source code so you can uncomment them (and comment out the others) and they should work. most configuration options were mapped in the settingsĭue to the limit of 20 components per device I commented out some of them in profiles/ring-gen2.yml.panic combination (hold simultaneously “X” and “Check” buttons).most alarms support strobe only and some support siren only.the PIN code can handle long pressed digits - they are then mapped to the letters:.setting the PIN code for the “disarm” and “arm home” buttons (you can set an empty PIN too).UPDATE 2: Looks like this has to be done with Intruder Alerts with Actions > create new monitor > Intruder actions > set entry delay and turn on alarms (keypad), then in Arm/Disarm under Any of these switches are on I set to the Arm(Away) virtual switch. Now I’m trying to figure out how to get the Ring Keypad to do the countdown arm sound when you begin Arm (away). After doing so I am able to setup Arm (home) from action tiles or via virtual switch and have it propagate down to the keypad and STHM. UPDATE: I installed WebCore and poked around until I found you have to add the virtual switches and keypad in, then create a web piston (didn’t know what that was) to fire off the logic shown above. I don’t have webcore installed, and when I went to add it, there was a setup asking about actuators, sensors (keypad is not an option) so it’s all a bit confusing. I saw a bit of script and am guessing that’s a webcore screenshot, but I’ve not seen detailed directions telling you exactly what to configure, where. I’m having the same trouble getting reverse Arm(Stay) state pushed to the device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |